Veo 802.11b - Manual (Page 55)

Page 55 of 69
5) Click Apply to save the settings. The Observer should now be configured to work with your router and be
accessible from the Internet.
Proxim (http://www.proxim.com)
ORiNOCO BG-2000 Broadband Gateway
1) Log into your router.
2) On the router's main page, click on Setup at the top of the page.
3) On the left side of the page, click on Advanced Settings->Port Forwarding.
4) Check in the checkbox for Enable Port Forwarding.
5) Click New on the right side of the page.
6) Enter the following information on the page:
Global Port: 80
Local Address: Type in the camera's IP address, for example: 192.168.253.3
Local Port: 80
Type: TCP
7) Click Save to save the settings.
8) Click New on the right side of the page.
9) Enter the following information on the page:
Global Port: 1600
Local Address: Type in the camera's IP address, for example: 192.168.253.3
Local Port: 1600
Type: TCP
10) Click Save to save the settings.
11) Click Restart on the left side of the page to restart your router. The Observer should now be configured to
work with your router and be accessible from the Internet.
Siemens (http://www.speedstream.com)
SpeedStream 2602 - 2-Port DSL/Cable Router
SpeedStream 2623 - Wireless DSL/Cable Router
1) Log into your router.
2) After you are logged in, click on Advanced Setup->Virtual Servers.
3) Enter the following information on the page:
Line #1:
Private IP: Type in the camera's IP address. (Look on the Observer’s IP Address LCD
display for the last 3 digits of the camera’s IP address.)
Private Port: 80
Type: TCP
Public Port: 80
Line #2:
Private IP: Type in the camera's IP address. (Look on the Observer’s IP Address LCD
display for the last 3 digits of the camera’s IP address.)
Private Port: 1600
Type: TCP
Public Port: 1600
4) Click Enter to save the settings. The Observer should now be configured to work with your router and be
accessible from the Internet.
SpeedStream 2604 - 4-Port DSL/Cable Router
1) Log into your router.
2) After you are logged in, click on Advanced->Virtual Servers.
3) Under the Properties section, there are a few entries you'll need to add. Check in the checkbox for Enable.
4) Under the first box, next to the Enable checkbox, type in: VeoWeb.