VTech 2428 - Manual (Page 5)

Before You Install
1. Choose a location for the Base near an electrical outlet and a telephone jack.
This phone requires a modular telephone jack and a standard electrical outlet (110v AC)
not controlled by a wall switch. Plug the AC power adaptor into the electrical outlet and
the DC connector to the jack on the bottom of the Base Unit.
2. Install the handset battery pack. Use only battery pack provided or recommended by
VTECH.
a)R e m o v e b a t t e r y
compartment cover
by pressing on the
i n d e n t a t i o n a n d
sliding downward.
b)Align the two holes in the plug with the
socket pins, then snap the plug into
place.
c) Place battery pack in the compartment
with the wires in the lower left corner,
along the bottom of the battery pack.
d)Replace cover by sliding it
up into place.
3 Attach the belt clip to the cordless handset (optional).
To attach To remove
NOTE: Install the Base Unit away from electronic equipment, such as personal computers,
INSTALLATION
3