VTech 2428 - Manual (Page 6)

television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Table/Desk Installation
CONNECT THE POWER CORD
CONNECT THE
TELEPHONE LINE CORD
Standard electrical outlet
Modular telephone jack
4. Charge the handset battery.
Place the handset in the base. Charge the battery for at least 12 hours the first time.
5. Check for dial tone
After the batteries are charged, connect the modular telephone cord between a live phone jack
and the jack located on the bottom of the Base Unit. Pick up the Handset and press PHONE.
You should hear a dial tone.
6. Set the dial mode.
If you have touch tone service, the phone is ready to use as soon as the batteries are charged.
If you have dial pulse (rotary) service, you’ll need to change the dial mode.
•
Press PROG/CHAN on the handset to enter programming mode.
• Press or until the screen displays DIAL MODE : and the currently selected mode.
• Press SELECT. The current setting blinks.
• Press to select TONE or PULSE .
• Press SELECT, to save the displayed mode.
INSTALLATION
4