Wolf Steamer - Manual (Page 12)

13
W O L F S T E A M E R M O D U L E U S E & C A R E
N O W A T E R I N S T E A M E R B A S I N
If there is no water in the steamer basin and
the steamer module is turned on, the unit will
beep three times, the light in the ”key” touch
pad will flash and the word “Lo” will appear in
the temperature display. Power to the heating
element will be automatically turned off and
the unit will enter Lock mode.
Add water to the steamer basin. Touch
to reset the control and begin normal opera-
tion once the unit exits Lock mode.
IMPORTANT NOTE: If the unit has entered
into this safety feature, it may require a few
minutes for the electronic sensors to stabilize
after water has been added.
D R A I N S T R A I N E R
A screen drain strainer is installed into the
drain outlet to keep food particles from
clogging the drain valve. The strainer should
remain in the drain outlet during normal use
and cleaning. Lift the drain strainer out and
rinse after each use to remove food particles.
WAT E R L E V E L S A F E T Y F E A T U R E
W A T E R L O W I N S T E A M E R B A S I N
During extended use, water in the steamer
basin may boil off to a level that could damage
the unit. If this occurs, the unit will beep three
times, the light in the ”key” touch pad will
flash and the word “Lo” will appear in the
temperature display. Power to the heating
element will be automatically turned off and
the unit will enter Lock mode.
Add water to the steamer basin to a level
above the minimum water level line. Touch
to reset the control and begin normal
operation once the unit exits Lock mode.
IMPORTANT NOTE: If the unit has entered
into this safety feature, it may require a few
minutes for the electronic sensors to stabilize
after water has been added.
Minimum water
level line