Wayne-Dalton TELEPORT WDHC-20 - Manual (Page 11)

11
SETTING UP A COMBO UNIT
TV/VCR or TV/DVD Code
TV Code (if used)
If you own a combo unit such as a TV/DVD Combo or a
TV/VCR Combo, follow the Steps below:
2. On Teleport™ press DVD/VCR once; it will
blink once. Then press and hold SETUP until the
DVD/VCR mode key blinks twice.
4. Aim Teleport™ at your combo device (for
example TV/DVD combo) and press PWR once.
The device should turn off. If it does not respond,
repeat steps 2 and 3, trying each code listed for
your brand until one works. If it still does not
respond, try searching for the code. See
“Searching for Your Code” starting on page 12.
3. Use the “Manufacturer’s Codes” starting on page 28 to
locate the brand name and enter the first five-digit code for
your combo device(for example, TV/VCR.) If you perform
this procedure correctly, the DVD/VCR key will blink twice.
Note: If the DVD/VCR mode key did not blink twice after
entering the last digit of the code, repeat steps 2 and 3
entering the same code again.
If the setup code that works for your combo device (for
example, TV/DVD combo) also has a separate TV code
listed, programming the separate TV code into Teleport™ is
necessary for TV volume and channel control. See
“Programming Device Control” on page 9.
1. Turn on your TV/DVD Combo and insert a DVD, or if
TV/VCR Combo, insert a video cassette.
5. For future reference, write down each working device
code in the boxes below:
PWR