Wayne-Dalton TELEPORT WDHC-20 - Manual (Page 19)

19
RE-ASSIGNING DEVICE MODE KEYS
To Re-Assign Perform Key Sequence
The Teleport™ remote control can be set up to control a
second device of an already-assigned mode. For example,
to have Teleport™ control a TV, cable converter box and
two audio receivers, re-assign the unused DVD/VCR mode
key to operate the second audio receiver as follows:
NOTE: DVD/VCR is preset at the factory to control an RCA
DVD. Performing the steps below will overwrite those
settings.
1. On Teleport™ press DVD/VCR once: it will
blink once. Press and hold SETUP until the
DVD/VCR key blinks twice.
2. Enter 992 on the numeric keypad.
3. Press AMP once, then press DVD/VCR once.
The DVD/VCR mode key will blink twice.
The DVD/VCR key is now ready to be programmed for your
second audio receiver. See “Programming Device Control”
on page 9. To re-assign other mode keys, repeat these
steps and substitute the key sequence using the following
chart:
NOTE: Only one mode can be assigned to an unused mode
key at a time.
DVD/VCR as
DVD/2nd AMP
DVD/VCR as
DVD/2nd TV
DVD/VCR as
2nd SAT
DVD/VCR
back to VCR
VCRSETUP992
AMPDVD/VCR
VCRSETUP992
TVDVD/VCR
VCRSETUP992
TVDVD/VCR
VCRSETUP992
DVD/VCR DVD/VCR