Wayne-Dalton TELEPORT WDHC-20 - Manual (Page 12)

12
SEARCHING FOR YOUR CODE
If your home entertainment device does not respond to the
Teleport™ remote control after trying all of the codes listed
for your brand, or if your brand is not listed at all, try
searching for your code using the following procedure:
NOTE: The example shown below is for a TV, to search
for codes of other devices, substitute the appropriate mode
key (e.g. DVD/VCR, AMP or SAT) for the device you are
searching for.
1. Turn on your TV.
2. On Teleport™, press TV once; it will blink
once. Then press and hold SETUP until the TV
key blinks twice.
3. Enter 991. The TV key will blink twice.
4. Aim Teleport™ at the TV and press PWR
once.
5. Press and release the CH+ key continuously
until the TV turns off.
NOTE: In the search mode, Teleport™ will
send IR codes from its library to the selected
device, starting with the most popular code
first.
6. Press PWR. The TV should turn on, then
press SETUP to lock in the code.
NOTE: If the TV does not turn on during step 6,
then slowly press and release CH- to back
through the codes. When the TV turns on press
SETUP to lock in the code.