Wayne-Dalton TELEPORT WDHC-20 - Manual (Page 17)

17
3. Enter 993 on the numeric keypad. The
last-selected device key will blink twice.
3. Press VOL- once. The last-selected device
key will blink twice.
5. Repeat Steps 1 - 3 for each device you want
volume to be unlocked.
Now, after you select a device that has volume
unlocked (e.g. SAT) pressing VOL+, VOL-, or
MUTE will control only that device’s volume
1. On Teleport™ press and hold SETUP until the
last-selected mode key blinks twice.
2. Enter 993 on the numeric keypad. The
last-selected device key will blink twice
3. Press VOL+ once. The last-selected device
key will blink four times.
Unlocking All Volume Control
(Global Volume Unlock)
NOTE: Performing these instructions will set independent
volume control for all programmed devices.
Unlocking Volume Control for a Single Device
(Individual Volume Unlock)
1. Assuming Global Volume Lock is active,
select a mode on the Teleport™ remote
control that you want to unlock (e.g., SAT)
and press it once.
2. Next, press and hold SETUP until the
device key blinks twice.
Continued next page...