Full speed usb, Serial – Worth Data 5000 User Manual
Page 38
37
FULL SPEED USB
If you are using Windows and you wish to use the Hardware Utilities to upload data via USB in full speed, choose FULL SPEED USB
for the HOST interface. You will also be able to do program uploads/downloads, firmware upgrades, voice uploads, and table
downloads. The first time you plug in a C22 USB cable between the TriCoder and a host, you will be required to install the full speed
TRICODERUSB driver that is supplied on your Utilities CD-ROM, (also available on our website, www.barcodehq.com under
Downloads). The first time you attempt to use Non-Portable Mode, you may be asked by the operating system to install the USB
Keyboard HID driver, which is probably on your hard disk, but if not, is on your original Windows CD ROM. While the TriCoder is set
for FULL SPEED USB it will enumerate as an HID KEYBOARD in Non-Portable Mode automatically.
SERIAL
The TriCoder can also be used as a RS-232 Serial Upload device to talk to any computer with a RS-232 COM Port Interface. Select
SERIAL for HOST option if you will be uploading to a serial port. You will need our C24 Serial cable to connect this way.
Serial parameters include Baud Rate, Parity, Data Bits & Protocol. You can upload to a computer running Windows using our
Hardware Utilities or you can use any serial communication program of your choice to receive files from the TriCoder on any
operating system.