Worth Data 5000 - Manual (Page 86)

85
TABLE FORMAT ERROR
PRESS ANY KEY_
The table header is in an invalid format
or EOF Ctrl Z (ASCII 26) is missing. Check table file for format
errors. Try again.
TABLE NOT FOUND
HIT ANY KEY_
A table referenced in a data collection
program does not exist. Download table or correct
program to reference correct
table.
UPLOADING DATA
PLEASE WAIT_
Collected data is being uploaded to
host. Wait for upload to finish.
USB Enumeration
Please wait… At power on or when a cable is plugged
in, TriCoder must enumerate as a USB
device. Also happens when changing
modes. Just wait a few seconds.
There is nothing to do.
Advisory only.
USB not Connected
Connect Cable,
Then Press a Key
Or F1 to Exit
Computer Interface is set to USB.
A mode has been selected to transfer
data. The USB cable is not plugged in.
Connect USB cable and press
a key or F1 to Exit to Mode
Menu.
USB not Connected
Connect, Hit any Key
or F1 – Exit
or F2 – Display Only
You have answered YES to Non
Portable Mode when the TriCoder is
configured for USB interface and NOT
connected to the USB port on the
computer. If you want to see the data on
the computer, connect to the
USB port, then press any key.
Press F1 to exit Non Portable
Mode or press F2 to simply
display the data on the
TriCoder
screen without
transmitting to the computer.
USB not Connected
Connect, Hit any Key
or F1 – Exit
or F2 – Delete File
You have answered YES to Data
Upload Mode when the TriCoder is
configured for USB Interface and is
NOT connected to the USB port on the
computer. If you want to upload via the
USB
port, connect the
TriCoder to the USB port and
press any key. Press F1 to
exit Data Upload Mode or
press F2 to delete the data file
from the TriCoder without
transmitting it to the computer
WARNING: 2K OF MEMORY LEFT
HIT ANY KEY_
You are close to filling the memory and
should upload before you can collect
any more data. HIT ANY KEY. Upload data
and
continue with data
collection.
WARNING: LOW BATTERIES
HIT ANY KEY TO CONTIINUE
The battery charge level is getting low.
If you continue to the use the TriCoder
it will automatically shut down when the
battery is depleted. Charge the battery and
resume operation.
WRONG INPUT DEVICE
HIT ANY KEY_
The input device you are using is not
what is specified in your program. Use the correct input device or
change the specification in
your program.