Preventing duplicate entry of data, Downloading a table to the tricoder, Troubleshooting – Worth Data 5000 User Manual

Page 83

Advertising
background image

82

08000000000EXAMPLE2
11111111
22

xxxxxx

33333

xxx

44444444
Ctrl Z

(ASCII 26) (use if a DOS file)

EXAMPLE2

above would accept a scan or entry of 22 when EXAMPLE1 would not.

Preventing duplicate entry of data

Sometimes you might want to make sure that an item in your table is not scanned or entered twice. You can prevent duplicate data
when using a data validation table by specifying the following in the DATA ID field:

Data ID entry

description

D1D

Prevent duplicate entry for Table

If you have specified DxD in the DATA ID field and happen to enter the same data twice, the TriCoder will respond with the
following error message:

DUPLICATE ACCESS
HIT ANY KEY_

Hit any key to return to the statement prompt again.

The file format to prevent duplicate access for table data validation looks almost identical to the above example for simple data
validation with a few exceptions:

As with the original example, the header record uses the first 2 digits to specify the data length, but the next 3 characters are F01
(specifies duplicate entry) and each data record has an additional 0 added to the low order position:

06F01000000EXAMPLE1
1111110
2222220
3333330
3242110
3656670
Ctrl Z

(ASCII 26)

The TriCoder uses the 0 (zero) at the end of each record to determine whether a record in the table has been accessed or not. When a
record is accessed, the 0 (zero) changes to a 1. If the user enters the same data twice, the TriCoder will look at the table and see a 1 at
the end of the matching data, indicating that the record had been accessed previously. Once accessed, the table cannot be reset to its
original status. You would have to re-download the table to use the table in its original format.

Downloading a table to the TriCoder

Tables are downloaded to the TriCoder using the Hardware Utilities on a Windows PC by either Full speed USB or Serial. Before
you can download a table, you must have:

o Programmed the TriCoder to work with Tables
o Setup the TriCoder I/O Settings as either Serial or Full Speed USB (Windows)

See

Chapter 9: Using the Integrated Hardware Utilities

for instructions and details on downloading a table using the Hardware

Utilities.

Advertising