Wayne-Dalton Z-WAVE WDTC-20 - Manual (Page 12)

12
Step 5: Match Wiring
Installation
FROM
FURNACE
W RH G C
3 Wire Heat + C
Wire C W RH G
Match the wiring diagram below with the wires you labeled in Step 3 and proceed to the
page referenced for detailed set-up information for your application.
note:
The C wire (24 Volts AC) is not optional.
note: If your combination of wires in not shown, go to Step 6 and modify your labeling per
the cross reference chart.
FROM
FURNAC
E
C
W
RH
2 Wire Heat + C
Wire C W rH
FROM
FURNAC
E
C
W RH Y G
4 Wire Heat/Cool + C
Wire C W rH Y G
5 Wire Heat/Cool + C
Wire C W rH Y G rC
FROM
FURNAC
E
C
W RH Y G RC
FROM
FURNAC
E
C G RH Y
B
O
or
4 Wire Heat pump without
auxilliary Heat + C
Wire C B rH Y G o or
FROM
FURNAC
E
C
W RH Y G W2
1 Stage Cool, 2 Stage Heat + C
Wire C rH Y G W2 W
FROM
FURNAC
E
W RH A C
3 Wire Zoned Hot Water + C
Wire C W rH a
Go to page 14
FROM
FURNAC
E
C W2 RH Y G
B
O
or
5 Wire Heat pump with
auxilliary Heat + C
Wire C B rH Y G o or W2
Go to page 14
Go to page 15 Go to page 15
Go to page 16 Go to page 16
Go to page 17 Go to page 17