Wegener Communications UNITY 4600 - Manual (Page 23)

wegener.com 800032-01 Rev. G 17
C
HAPTER
2 I
NSTALLATION
This chapter provides instructions on unpacking, mounting, and connecting your Unity
4600 as well as connector information including detailed pinouts.
2.1 Unpacking and Inspection
Carefully unpack the unit and its ac power cord and inspect for obvious signs of
physical damage that might have occurred during shipment. Any damage claims must
be reported to the carrier immediately. Be sure to check the package contents
carefully for important documents and materials.
Note: Please save the packing materials and original shipping containers in case
you must later return the unit for repair. Packing these units in other
containers in such a way that they are damaged will void your warranty.
2.2 Location and Mounting
The Unity 4600 may be mounted in a standard 19-inch equipment rack or set up for
desktop operation. In either location, maintain a clean, dry environment for your Unity
4600 .
FCC-mandated suppression of radiated emissions
If the Ethernet port has a cable connected to it, that cable MUST be properly shielded
and grounded. This must be done to minimize RF emissions which could interfere with
nearby equipment.
WA R N I N G This is a Class A product. In a domestic environment this product may cause radio
interference for which the user may need to take mitigating action.
D A N G E R To avoid damage to this and other equipment, or personal injury, the following items
should be strictly observed.
Elevated Operating Ambient
When equipment is installed in a closed or multi-unit rack assembly, the operating
ambient of the rack environment may be greater than the room ambient. Therefore,
consideration should be given to the ambient air temperature within the rack, and not
just inside the room, when deciding if the maximum recommended ambient operating
temperature (T
MRA
) is being met.
Reduced Air Flow
Equipment should be installed such that airflow required for safe operation of the
equipment is not compromised. The
Unity 4600 may be arranged in a rack without
empty spaces between units if heat rise is prevented by ensuring its side vents remain
unblocked with adequate clearance around the vent holes.