Wegener Communications UNITY 4600 - Manual (Page 45)

www.wegener.com 800032-01 Rev. G 39
Unity 4600 User’s Manual
PID: Hex number between 1 and 1FFE (except 11 , reserved for SDT ).
Command to add or delete entries in the list of ghost PIDs to pass to the ASI transport output (while
Program Mapping is enabled). Entering command without the action or pid parameter
dumps the current list.
H [command]
command: Any of the terminal command names (PC, R, PORT, etc.).
If an H or any invalid command beginning with an H is entered and command is omitted, the whole help
screen will be displayed, consisting of a list of all currently available commands and a brief
description of each listing. If an
H or any invalid command beginning with an H is entered
and command is a valid User Command Name, then detailed help for command is displayed.
A Local Control Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).
INDPERS indication time
indication: A or Alarm or W for Warning.
time: Time in seconds.
Command to set the minimum indication-time persistence for either Alarms or Warnings, per the value
of indication, for the time period given by time. Entering command without parameters
shows the current settings. A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
IPCONFIG
Command requests report of all current IP parameters (IP address, Gateway address, subnet mask) and
assignment mode (static or DHCP). A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
LAN GATEWAY addr
addr: IP address formatted as n1:n2:n3:n4 where n1 , n2 , n3 , and n4 are integers between 0 and
255 .
Command sets the IRD’s static internet Gateway IP address. No protection is offered against entry of
non-standard addresses (e.g. 0:0:0:0). Omitting the addr parameter shows the current static
Gateway IP. This will not be the current Gateway IP address if dynamically assigned. Use
the
IPCONFIG command for that. A Local Control Command (available from the terminal
regardless of "Local Control Enable/Disable" commands from the network).
LAN IP addr
addr: IP address formatted as n1:n2:n3:n4 where n1 , n2 , n3 , and n4 are integers between 0 and
255 .
Command sets the IRD’s static IP address. No protection is offered against entry of non-standard
addres-ses (e.g., 0:0:0:0). Omitting the addr parameter shows the current static IP. This will
not be the current IP address if dynamically assigned. Usethe IPCONFIG command for that.
A Local Control Command (available from the terminal regardless of "Local Control Enable/
Disable" commands from the network).