Xerox -05W - Manual (Page 103)

7-29
Setup Menus
NCSI Settings
This TeemTalk for Windows 3.1x dialog box is displayed by clicking the Configure...
button in the New Connection dialog box when the connection
type is set to Extended NCSI.
Baud Rate
Factory default: 9600
This specifies the transmit and receive baud rates in the range 50 to 115200 baud.
Parity
Factory default: None
This option specifies the parity mode for each transmitted character.
If the number of Data Bits is 8, set this option to None.
Selecting Odd will cause an eighth bit to be added with a value of 1 if the previous 7
bits add up to an even number, and 0 if the previous 7 bits add up to an odd number.
Selecting Even will cause an eighth bit to be added with a value of 1 if the previous 7
bits add up to an odd number, and 0 if the previous 7 bits add up to an even number.
Mark parity will set every eighth bit to 1 and Space parity every bit to 0.
Flow Control
Factory default: Xon/Xoff
This option specifies the type of flow control used to communicate readiness to
transmit or receive data from the host. It can be set to None, DTR, RTS, DTR/RTS
or Xon/Xoff.