Xerox -05W - Manual (Page 18)

2-4
Getting Started
Note: The options in this dialog box are described in the Serial
Settings section in the Setup Menus chapter and only apply
when the connection type is set to Serial.
The status bar along the bottom of the TeemTalk window displays two LEDs. The first
LED indicates whether or not you are connected to the host. It will show red when
not connected and green when you are connected. The second LED indicates
whether or not data is being sent to or from the host. It will show dull green when
there is no activity, red when data is being sent to the host, and bright green when
data is being received from the host.
Making A Network Host Connection
To connect to a network host, select the protocol required in the Type list box:
TeemTalk for Windows 95 and NT:
TCP/IP CTERM WinSock 2
NetBIOS MultiLan ISDN
LAT Microsoft SNA TeemTalk-OSI (option)
TeemTalk for Windows 3.1x:
LAT NetBIOS B and W. TCP INFOConnect
FTP PC/TCP OSLAN WinSock ISDN
Sun PC/NFS TELAPI Ext. NCSI DOSLANTI
LAN W/Place BAPI Eicon X25 MultiLan
NetManage Interrupt 14 IPX/SPX
PathWay INT6B / NASI NetWare for LAT
CTERM LanManager TeemTalk-OSI
Note: Refer to the Network Connection chapter in the Networking
Guide for a description of each protocol supported and for
any additional configuration required prior to making a
connection.