Xerox -05W - Manual (Page 290)

12-86
Creating A Script File
FTU SET & GET Parameters
This section lists the parameters available for the script language FTU SET and FTU
GET commands, together with the values they will accept or return. The actual value
may be specified in upper or lower case, may have double quotes to delimit it as a
string, or may be a previously defined variable.
The list of parameters and values are shown under the following headings:
GroupID identifies a group of parameters (default is CURRent).
ParamID identifies a particular parameter, or in the case of Parameter
settings a sub-group of parameters.
SubParamID identifies a particular parameter for Parameter settings.
Value
is the value to be set or returned.
The Value will be in one of the following formats if not specifically given:
immediate no value required, 0 or 1 returned.
boolean 0 or 1, No or Yes, True or False, OFF or ON.
string a control character (e.g. CR) or its decimal value
enclosed by double quotes.
range one of a range of integers as shown (e.g. range 1 -3).
integer any number.
Transfer Protocol Settings
GroupID ParamID Value
Kermit: TRANSFER KERMIT immediate
XMODEM: TRANSFER XMODEM immediate
XMODEM-1K: TRANSFER XMODEM-1K immediate
YMODEM Batch: TRANSFER YMODEMBATCH immediate
ZMODEM TRANSFER ZMODEM immediate
ASCII TRANSFER ASCII immediate
General Parameter Settings
GroupID ParamID SubParamID Value
Timer: PARAMETER GENERAL TIMer boolean
Warning Bell: PARAMETER GENERAL BELl boolean
Discard Partial: PARAMETER GENERAL DIScard boolean
D. File Warning: PARAMETER GENERAL FILEWarn boolean
Send Delay: PARAMETER GENERAL SENDDelay range 0 - 63
Retry Limit: PARAMETER GENERAL RETRYlimit range 1 - 63