Sending to an e-mail address, P.70 “sending to an e-mail address – Xerox C3000 User Manual

Page 80

Advertising
background image

Transmission

70

1

Note

❒ To send to a G3 fax via a gateway connected to a public telephone line, you

must specify the receiver's machine telephone number. For example, if the re-
ceiver's fax number is “0312345678”, specify “5678”. To send from an IP-Fax
to G3 fax without using gatekeeper or SIP server, you must register the gate-
way also.

❒ When you specify a destination with IP-Fax, depending on the receiver's net-

work configuration, you may need to specify the IPv4 address and port num-
ber of the receiving machine. For example, if the receiver's IPv4 address is
“192.168.1.10” and the port number is “2100”, specify “192.168.1.10:2100”.
Ask the network administrator for details.

❒ When you specify a host name, depending on the receiver's network config-

uration, you may need to specify the host name and port number of the re-
ceiving machine. For example, if the receiver's host name is “IPFAX1”and the
port number is “2100”, specify “IPFAX1:2100”. Ask the network administra-
tor for details.

❒ An alias telephone number is a number that is registered in the gatekeeper,

and is available only in the network to which the gatekeeper is connected.

❒ Pay attention to the number of telephone number digits set in the gate-

way/IPv4 address conversion table to avoid transmission error.

Sending to an E-mail Address

This section explains how to specify an e-mail address as a destination.
When using Internet Fax transmission, specify the e-mail address in place of the
fax number.

Important

❒ In the destination list, register senders, specify their e-mail addresses, and set

the User Name as [Sender] in advance.

❒ Internet Fax is executed in only Memory Transmission that starts transmis-

sion automatically after storing documents in memory. If you switch the type
of transmission to Internet Fax while the machine is in the Immediate Trans-
mission mode, the transmission mode is automatically switched to the Mem-
ory Transmission mode.

Advertising