Assigning an ip address, With dynamic host configuration protocol (dhcp), Without dhcp – Zebra Technologies ZebraNet ZM400TM User Manual
Page 41
41
Getting Started
Assigning an IP Address
04/19/2007
ZebraNet
®
10/100 Internal Print Server for ZM400 and ZM600 User Guide
14197L-001 Rev. A
Assigning an IP Address
Before you can begin working with 10/100 Internal PS, you must get or assign an IP address
for the 10/100 Internal PS device.
There are four different ways to assign an IP address. Here is a list and a brief description of
each method:
• Web View — Browser-enabled method to assign an IP address.
• ZebraNet View — Utility that remotely manages ZebraLink-enabled printers.
• DHCP — See your LAN administrator for more information.
• Telnet — DOS command to assign an IP address.
With Dynamic Host Configuration Protocol (DHCP)
If your network uses DHCP, your 10/100 Internal PS device is assigned a temporary IP
address.
Without DHCP
If your network does not use a dynamic IP addressing system (such as DHCP), you need to set
a permanent IP address for the 10/100 Internal PS device. ZebraNet View is the
Windows-based print server management and configuration utility that comes with your
10/100 Internal PS.
Important •
Throughout the procedures in this chapter, there are some features that require the
default User ID and/or default password. If you are prompted, these are the defaults:
•
User ID:
admin
•
Password:
1234
Note •
Check with your Network Administrator to see whether your network uses DHCP.
Important •
The remaining sections are dependent on the successful installation of ZebraNet
Utilities. To install, see
.