Yamaha RX-V2400 - Manual (Page 27)

23
English
CONNECTIONS
PRE
P
ARA
T
ION
If you are using 6 ohm speakers, set the impedance to 6
ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1
On the front panel, while pressing down
SPEAKERS A, press STANDBY/ON.
“SP IMP.SET” appears on the front panel display for
a few seconds, then “Minimum 8ohms” appears.
2
Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
y
You can also use SP IMP.SET (see page 57) to set the speaker
impedance.
When all connections are complete, turn on the power of
this unit.
1
Press STANDBY/ON (SYSTEM POWER on
the remote control) to turn on the power of
this unit.
2
Turn on the video monitor connected to this
unit.
Speaker impedance setting
CAUTION
SPEAKERS
A
STANDBY
/ON
SP IMP.SET
Minimum 8ohms
Turning on the power
VOLUME
VIDEO AUX SILENT REC OUT /ZONE 2
SPEAKERS
INPUT
MULTI CH INPUT INPUT MODE
PRESET/
TUNING
PHONES
SOURCE /REMOTE MD/TAPE CD–R TUNER
CD
DVD D–TV CBL/SAT
VCR 1
/VCR2 DVR
A/B/C/D/E
S VIDEO
MEMORY FM/AM
EDIT
PRESET
/TUNING
MAN'L/AUTO FM AUTO/MAN'L MONO
TUNING MODE
VIDEO AUDIO OPTICAL L R
STANDBY /ON
A B
OPTIMIZER MIC
TONE CONTROL
PROGRAM
STRAIGHT
EFFECT
1
TRANSMIT RE-NAME
STANDBY
INPUT MODE
SOUND
SYSTEM
CLEAR LEARN MACRO OFF ON MACRO
PHONO MULTI CH IN
CD
DVD DVR/VCR2 VCR 1
TITLE
MENU
CHAPTER
PAUSE STOP POWER REC
SELECT
DISPLAY
SEARCH
SOURCE
PLAY
– +
ENTER
DTV CBL/SAT
CD-R MD/TAPE TUNER V-AUX
POWER TV POWER 1
(U.S.A. model)
STANDBY
/ON
SYSTEM
POWER
or
Front panel Remote control
00_RX-V2400U_EN.book Page 23 Friday, October 10, 2003 10:54 AM