Yamaha RX-V2400 - Manual (Page 80)

76
EDITING SOUND FIELD PARAMETERS
5
Press –/+ to change the parameter value.
When you set a parameter to a
value other than the factory
value, an asterisk mark (*)
appears by the parameter name
on the video monitor.
6
Repeat steps 3 to 5 above as necessary to
change other program parameters.
• The available parameters may be displayed on more than one
OSD page for some of the programs. To scroll through pages,
press k/n.
• You cannot change parameter values when MEMORY GUARD
is set to “ON”. If you want to change the parameter values, set
MEMORY GUARD to “OFF” (see page 56).
■ Resetting parameters to the factory
values
To reset a certain parameter
Select the parameter you want to reset, then press –/+
repeatedly until the asterisk mark (*) next to the parameter
name disappears from the video monitor.
To reset all parameters
Use PARAM.INI (see page 57).
Notes
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
00_RX-V2400U_EN.book Page 76 Friday, October 10, 2003 10:54 AM