Yamaha RX-V2400 - Manual (Page 60)

56
SET MENU
■ Display set DISPLAY SET
MANUAL SETUP > OPTION MENU >
DISPLAY SET >
Dimmer DIMMER
Use to adjust the brightness of the front panel display.
Choices: –4 to
0
OSD shift OSD SHIFT
Use to adjust the vertical position of the OSD.
Choices: +5 (downward) to –5 (upward)
• Press + to lower the position of the OSD.
• Press – to raise the position of the OSD.
Gray back GRAY BACK
Selecting AUTO for the on-screen display setting displays
a gray background when there’s no video signal input.
Nothing is displayed if OFF is selected.
Choices:
AUTO , OFF
If “GRAY BACK” is set to OFF, no information will be displayed
on the screen when video signals are not being input.
Video conversion V CONV.
Use this feature to turn on/off the conversion of composite
signals to both S-video and component signals. This
allows you to output composite signals from the S-video
jack or the component video jack when no S-video or
component signals are input. This feature also converts S-
video signals to component signals when no component
signals are input.
Choices:
ON , OFF
• Select OFF not to convert any signals.
• Select ON to convert composite signals to S-video and
component signals, and to convert S-video signals to
component signals.
• Converted video signals are only output to the MONITOR OUT
jacks. When recording you must make the same type of video
connections (composite or S-video) between each component.
• When converting S-video signals from a VCR to component
video signals, the picture quality may suffer depending on your
VCR.
Component OSD CMPNT OSD
Use this feature to turn on/off the OSD when you are using
COMPONENT VIDEO MONITOR OUT jacks while
using the set menu.
Choices:
ON , OFF
• Select ON to output the OSD signals from
COMPONENT VIDEO MONITOR OUT jacks while
using the set menu.
• Select OFF if you do not want to output the OSD
signals from COMPONENT VIDEO MONITOR OUT
jacks while the using set menu.
Set menu functions even when OFF is selected.
■ Memory guard MEMORY GUARD
Use this feature to prevent accidental changes to DSP
program parameter values and other system settings.
MANUAL SETUP > OPTION MENU >
MEMORY GUARD >
Choices: ON, OFF
Select ON to protect:
• DSP program parameters
• All SET MENU items
• All speaker levels
• The on-screen display (OSD) mode
When MEMORY GUARD is set to ON, you cannot use
the test tone or select any other SET MENU items.
Manual setup: OPTION
Note
. A)DISPLAY SET
B)MEMORY GUARD
C)PARAM. INI
D)ZONE SET
: Up/Down
p
/p
: Select - / +
4 OPTION MENU
/ : Up/Down
p
p
-/+ : Select
. DIMMER;;;;;;;;;0
OSD SHIFT;;;;;;0
GRAY BACK;;;AUTO
V CONV.;;;;;;;ON
CMPNT OSD;;;;OFF
A)DISPLAY SET
Notes
Note
/ : Exit
p
p
-/+ : Select
[OFF ON
B)MEMORY GUARD
00_RX-V2400U_EN.book Page 56 Friday, October 10, 2003 10:54 AM