Zebra Technologies P310F - Manual (Page 12)

4
980261-001 Rev. B
The following will guide you through the
installation of your P310 Printer.
PRINTER
INSTALLATION
CAUTION: Limit AC power supplied to the P310
to 110 ~ 230 volts, 60 ~ 50 Hertz, for an
associated 680 ~ 280 milliamps. Limit excess
current draw to 16 amps or less, using an associated
circuit breaker or other such device. Never operate
the printer in a location where operator, computer,
or printer can get wet. Personal injury could result.
The electrical security of the printer is based on
the reliability of the mains power source.
1. Place the printer in a location that allows easy access
to all sides. The printer should never be operated while
resting on its side or upside down.
2. Place the printer's power swith in the OFF (0) position.
3. Insert the power cable into the printer power socket
and attach to grounded electrical socket of the proper
voltage and type.
4. Attach interface cable to printer and computer and
then secure.
5. Switch power on.
CAUTION: Intermittent or unpredictable
operation may occur from unsecured connectors.
If damaged, the power cable must be replaced by
an exact equivalent.