Zebra Technologies MtP400 - Manual (Page 14)

Getting Started
Belt Loop System
The belt loop system consists of two parts – a knob located on the bottom of the printer and a belt loop strap
with a click on connector
To use the belt loop system, slide your belt through the strap of the belt loop and then insert the knob located on
the bottom of the printer into the slot of the belt loop connector. Pull down on the printer until you hear a click.
The printer is now secure and can safely hang down beside your hip.
To release the printer, press in on the two latches on the sides of the connector and pull the printer and knob up
and clear of the slot.
Note: Do not force or pull the printer from the connector without pressing in on the two latches.
8