Zebra Technologies MtP400 - Manual (Page 30)

Printer Configuration
IrDA Interface
INTERFACE MENU
IrDA
Note that “IrDA” must be displayed on the bottom line of the display in order to access the following features
and for this interface to be active when Setup is exited.
Emulation Emulation
Printek
Possible Values: Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump
This feature sets the family of printer commands that may be used by a host application program to control the
various capabilities of the printer. The printer will only respond to commands valid for the currently selected
emulation. For more information, please refer to the MtP400 Series Programmer’s Manual.
Bluetooth Interface
INTERFACE MENU
Bluetooth
Note that “Bluetooth” must be displayed on the bottom line of the display in order to access the following
features and for this interface to be active when Setup is exited.
Emulation Emulation
Printek
Possible Values: Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump
This feature sets the family of printer commands that may be used by a host application program to control the
various capabilities of the printer. The printer will only respond to commands valid for the currently selected
emulation. For more information, please refer to the MtP400 Series Programmer’s Manual.
Note: After pressing the Enter Button to move from Emulation to Pairing Mode, the printer will pause
and display “Waiting for Bluetooth” while reading the current configuration from the Bluetooth
interface module.
24