Zebra Technologies MtP400 User Manual
Page 58
Specifications
Black Mark Position
The vertical position of a Black Mark is dependent on the application program that will be used to search for
and print relative to the mark. The following diagram shows the optimum position when seeking the Black
Mark at the beginning of a print job and will require little, if any, reverse paper motion. (Note that reverse
paper motion in MtP400 SL models is not supported.)
The Black Mark must be printed on the front side of the paper for the MtP400 and MtP400 SL models. It may
optionally be printed on the back side of the paper for use with the MtP400 LP models
0.9”
0.15”
Tear edge.
Front (thermal printed) side of
form.
Black Mark should span width
of paper for best results.
Figure 14 - Black Mark Position
Gap Sensing Specifications
Gap Sensing is only available for MtP400 LP models. The minimum gap between labels is 0.125” (3.2mm).
52