Yamaha RX-V3900 - Manual (Page 40)

36
En
1
Turn on the video monitor connected to this
unit.
y
• If you connect two video monitors to the HDMI OUT
jacks of this unit, press RHDMI OUT repeatedly to select
the active video monitor(s). See page 37 for details.
• You can operate this unit by using the graphical user
interface (GUI) screen (page 76).
• You can configure the display settings with “Video”
(page 93) and “Display Set” (page 98).
2
Rotate the C
INPUT selector (or press one
of the input selector buttons (3))
The name of the selected input source appears for a
few seconds.
3
Start playback on the selected source
component or select a broadcast station.
• Refer to the instruction manuals for the source
component.
• FM/AM radio tuning (page 48)
• XM Satellite Radio tuning (page 53)
• SIRIUS Satellite Radio tuning (page 58)
• Bluetooth component playback (page 64)
• iPod playback (page 66)
• Playback via USB or network (page 68)
4
Rotate P
VOLUME (or press JVOLUME +/–)
to adjust the volume to the desired output
level.
y
To adjust the level of each speaker, see page 47.
5
Rotate the M
PROGRAM selector (or press
one of the sound field program selector
buttons (Q) repeatedly) to select the desired
sound field program.
For details about sound field program, see page 40.
y
To switch the information (current input source, current
sound field program, etc) displayed in the front panel
display, press
KINFO (or set the operation mode selector
to FAMP and then press CINFO) repeatedly.
Playback
Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
y
To play DTS-encoded CDs when using a digital audio
connection, set “Decoder Mode” in “Input Select” to “DTS”
before the playback (page 85).
Before performing the following operations, set the operation
mode selector on the remote control to FAMP.
Basic procedure
DOCK V-AUX VCR DVR CBL/SAT DVD BD/HD DVD MD/CD-R TV CD PHONO MULTI CH TUNER XM SIRIUS
D V D
USB
NET
Selected input source
Available input sources
M o v i e
S c i - F i
Selected sound field program
Selected sound field program category