Yamaha RX-V3900 - Manual (Page 42)

38
En
Playback
Connect a pair of headphones with a stereo
analog audio cable plug to the PHONES jack on
the front panel.
y
When you select a sound field program, SILENT CINEMA
mode activates automatically (page 45).
• When you connect headphones, no signals are output at the
speaker terminals.
• All digital multi-channel audio signals are mixed down to the
left and right headphone channels.
• When “MULTI CH” is selected as the input source, only the
signals input at the MULTI CH INPUT FRONT jacks are
output.
Press L
MUTE on the remote control to mute the
audio output. Press L
MUTE again to resume
the audio output.
y
• The VOLUME level indicator flashes while the mute function is
on.
• You can configure the muting level with “Muting Type”
(page 90).
You can display the format, sampling frequency, channel,
bit rate and flag data of the current input signal.
1
Set the operation mode selector to F
AMP
and then press 8
STATUS on the remote
control.
The input source information screen appears in the
GUI screen.
2
Press 9l / h to toggle between the audio
and video information.
3
Press 8
STATUS on the remote control
again to exit from the input source
information screen.
■ Audio information
• “–––” appears when this unit cannot display the corresponding
information.
• Some high definition audio bitstream contents may not include
the discrete surround back left and right channel signals but are
encoded at the bitrate of 192 kHz.
• Even if you make settings to output bitstreams directly, some
players convert the Dolby TrueHD or Dolby Digital Plus
bitstreams to the Dolby Digital bitstreams, while converting the
DTS-HD Master Audio or DTS-HD High Resolution Audio
bitstreams to the DTS bitstreams.
Using your headphones
Notes
Muting the audio output
MASTER
PURE DIRECT
VOLUME
MAIN ZONE
INPUT
OFF ON
INFO
ZONE ON/OFF ZONE CONTROLS
MULTI ZONE
MIC OPTIMIZER
EFFECT
PROGRAM
YPAO
ZONE 3
R L OPTICAL
ZONE 2
AUDIO
VIDEO AUX
SILENT CINEMA S VIDEO VIDEO
PHONES
BAND
CATEGORY PRESET/TUNING/CH MONO STEREO/ MODE SEARCH MEMORY
STRAIGHT
MENU REC OUT AUDIO SELECT/ CONTROL TONE ENTER
ON/OFF
USB
Displaying the input source
information
Format Signal format. When this unit cannot detect a
digital signal, it automatically switches to
analog input.
Sampling The number of samples per second taken from
a continuous signal to make a discrete signal.
Channel The number of source channels in the input
signal (front/surround/LFE). For example, a
multi-channel soundtrack with 3 front
channels, 2 surround channels and LFE, is
displayed as “3/2/0.1”.
Bitrate The number of bits passing a given point per
second.
Dialogue The dialogue normalization level preset to the
current input bitstream signal.
Flag1/Flag2 Flag data encoded in the bitstream, or PCM
signals that cue this unit to automatically
switch decoders.
Notes