Yamaha RX-V3900 - Manual (Page 59)

55
En
XM® Satellite Radio tuning
BA
S
IC
OPERA
T
ION
English
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see “Setting the XM Satellite Radio preset
channels” (page 55).
1
Press H
SEARCH MODE (or ISRCH
MODE) repeatedly to select “PRESET
SEARCH”.
2
Press J
CATEGORY (or 9A-E/CAT. l / h)
repeatedly to change the preset channel
group (A to E).
3
Press F
PRESET/TUNING/CH l / h (or
9 PRESET/CH k / n) repeatedly to change
the preset channel number (1 to 8).
y
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (B).
■ Direct number access mode
1
Press I
SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
2
Press the numeric buttons (B) to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (B) as shown below.
y
• To display the XM Radio ID number in the front panel display,
select channel “0”.
• To enter a one-digit or two-digit channel number, press the
numeric buttons (B) on the remote control and then press
NENT to confirm the input number.
• Instead of pressing NENT to tune into the channel
immediately, you can wait a few seconds until this unit confirms
the entered channel number.
• Pressing a button other than the numeric buttons (B) or NENT
cancels the Direct Number Access mode procedure.
You can use this feature to store up to 40 XM Satellite
Radio channels (A1 to E8: 8 preset channel numbers in
each of the 5 preset channel groups). You can then recall
any preset channel easily by selecting the preset channel
group and number as described in “Preset Search mode”
(page 55).
1
Search for a channel you want to set as a
preset channel by using one of the XM
Satellite Radio search modes.
For details, see “XM Satellite Radio operations”
(page 54).
2
Press G
MEMORY (or 0MEMORY).
The PRESET indicator lights up in the front panel
and this unit automatically selects an empty preset
number.
y
• To store the selected channel under an empty preset
number automatically, press and hold GMEMORY (or
0MEMORY) for more than 2 seconds instead of step 2.
In this case, the following steps are unnecessary.
• To cancel the preset operation, press GMEMORY (or
0MEMORY) again.
3
To select the preset channel group and
number (A1 to E8), press
F
PRESET/
TUNING/CH l / h (or 9CAT./A-E l / h
and 9
PRESET/CH k / n) repeatedly.
• To select a higher preset channel group and
number, press Fh (or 9k).
• To select a lower preset channel group and number,
press Fl (or 9n).
1 2 3
Before performing the following operations, set the operation
mode selector on the remote control to FSOURCE and then
press 3XM.
Setting the XM Satellite Radio
preset channels
0 4 3 X M U
Channel number
PRESET
M E M O R Y A 1
0 4 3 X M U
Lights up