Yamaha RX-V3900 - Manual (Page 99)

95
En
Graphical user interface (GUI) menu
AD
V
ANCED
OPERA
T
ION
English
Input (HDMI IN jack select)
Use this feature to select an HDMI IN jack that accepts
HDMI signals when this unit is in the standby mode.
This setting is available only when “Mode” is set to “Fix”.
Output (HDMI OUT jack select)
Use this feature to select HDMI OUT jack(s) that output
HDMI signals when this unit is in the standby mode.
This setting is available only when “Mode” is set to “Fix”.
■ Audio Output (HDMI audio output)
Use this feature to select whether to play back HDMI
audio signals on this unit or on another HDMI component
connected to the HDMI OUT jacks on the rear panel of
this unit.
y
If “Audio Output” is set to “TV” or “Amp + TV”, available
audio signals vary depending on the specification of the
connected video monitor.
■ Control Monitor (Control monitor)
Use this feature to select the HDMI OUT jack at which
HDMI control signals are output.
■ Monitor Info. (Monitor information)
Use this feature to check the information (interface and
frequency for each video resolution) about the video
monitors connected to the HDMI OUT 1 and HDMI OUT
2 jacks of this unit.
y
Press 9h repeatedly to toggle between “OUT1” (information
about the video monitor connected to the HDMI OUT 1 jack )
and “OUT2” (information about the video monitor connected to
the HDMI OUT 2 jack ).
Use this menu to adjust the network parameters.
In case you changed your network configuration, you may
need to reconfigure the network settings.
y
You can reset the all parameters in “Network” to the initial
factory settings by using “NETWORK” of “INITIALIZE” in
“ADVANCED SETUP” (page 122).
■ Configuration (Network configurations)
Use this feature to view the network parameters (IP
address, etc.) or to change them manually.
DHCP (DHCP setting)
Use this feature to select whether this unit can obtain the
network parameters (IP address, subnet mask, default
gateway, primary DNS server and secondary DNS server)
from the DHCP server of the connected network.
IP Address (IP address)
Use this parameter to specify an IP address assigned to
this unit. This value must not duplicate the one used for
other devices in the target network.
Subnet Mask (Subnet mask)
Use this parameter to specify the subnet mask value
assigned to this unit.
y
For most of the cases, the subnet mask value can be set as
“255.255.255.0”.
Default Gateway (Default gateway)
Use this parameter to specify the IP address of the default
gateway.
Note
Choice HDMI IN jack
IN1 HDMI IN1 (BD/HD DVD) jack
IN2 HDMI IN2 (DVD) jack
IN3 HDMI IN3 (CBL/SAT) jack
IN4 HDMI IN4 (DVR) jack
Note
Choice HDMI IN jack
OUT1 + 2 HDMI OUT 1 and HDMI OUT 2 jacks
OUT1 HDMI OUT 1 jack
OUT2 HDMI OUT 2 jack
Choice Functions
Amp Outputs HDMI audio signals at the speakers
connected to this unit.
TV Outputs HDMI audio signals at the speakers of
the TV connected to this unit.
Amp + TV Outputs HDMI audio signals at the speakers
connected to this unit and speakers of the TV
connected to this unit.
Choice Functions
HDMI OUT1 Outputs HDMI control signals at the HDMI
OUT 1 jack.
HDMI OUT2 Outputs HDMI control signals at the HDMI
OUT 2 jack.
Setup (Network)
Note
Choice Descriptions
On Select this setting when this unit can obtain the
network parameters from the DHCP server of
the connected network.
Off Select this setting when you set the network
parameters manually.