Yamaha NOT FOND DSP-Z11 - Manual (Page 95)

Graphical user interface (GUI) menu
95
En
Ad
v
a
nce
d
Op
eratio
n
Source (Source)
After selecting the input source, you can set the function of the
TRIGGER OUT jacks when the corresponding input source is
selected.
Manual (Manual)
You can display the format, sampling frequency, channel, bit rate
and flag data of the current input signal.
■ Audio Info. (Audio information)
• “–––” appears when this unit cannot display the corresponding information.
• Some high definition audio bitstream contents may not include the discrete surround
back left and right channel signals but are encoded at the bitrate of 192 kHz.
• Even if you make settings to output bitstreams directly, some players convert the
Dolby TrueHD or Dolby Digital Plus bitstreams to the Dolby Digital bitstreams,
while converting the DTS-HD Master Audio or DTS-HD High Resolution Audio
bitstreams to the DTS bitstreams.
■ Video Info. (Video information)
HDMI error and message
Use this feature to select the language of the menu items and
messages.
Choices:
English (English), (Japanese),
Français (French), Deutsch (German),
Español (Spanish),
Русский (Russian)
y
You can also select the language using the “LANGUAGE” parameter in “Advanced
setup” in the front panel display (see page 120).
··· The selected language is displayed.
— ··· The selected language is not displayed. The menu items and
messages are displayed in English.
Choice Descriptions
Input High Sends the voltage when you select the input source
you set in “Source”.
Input Low Stops sending the voltage when you select the input
source you set in “Source”.
Choice Function
High Sends the voltage signals.
Low Stops sending the voltage signals.
Signal Info.
(Input signal information)
Format Signal format. When this unit cannot detect a digital
signal, it automatically switches to analog input.
Sampling The number of samples per second taken from a
continuous signal to make a discrete signal.
Channel The number of source channels in the input signal
(front/surround/LFE). For example, a multi-channel
soundtrack with 3 front channels, 2 surround channels
and LFE, is displayed as “3/2/0.1”.
Bitrate The number of bits passing a given point per second.
Dialogue The dialogue normalization level preset to the current
input bitstream signal (see page 131).
Flag1/Flag2 Flag data encoded in the bitstream, or PCM signals that
cue this unit to automatically switch decoders
(“Surround EX”, etc.).
Notes
HDMI Signal Type of the source video signals and the
video signals output at the HDMI OUT jack
on this unit.
HDMI Resolution Resolution of the input signal (analog or
HDMI) and the output signal (HDMI).
Analog Resolution Resolution of the source video signals and
the analog video signals output at the
COMPONENT MONITOR OUT jacks of
this unit.
HDMI Error
(HDMI Message) Error message for HDMI sources or
connected HDMI devices. See page 124 for
details.
Message Cause
Device Over The number of the connected HDMI components is
over the limit.
HDCP authentication failed.
Out of Resolution The connected monitor is not compatible with the
resolution of the input video signal.
Language
Language GUI menu
Front panel
display
Zone OSD
Русский
(Russian)
—
(Japanese)
— —
Other languages