Yamaha DSP-Z9 - Manual (Page 100)

98
USING i.LINK
If MULTI CH INPUT is assigned for the i.LINK
component
1
Press MULTI CH INPUT.
2
Press INPUT MODE repeatedly to set “Auto”
or “i.LINK” as the input mode.
3
Start playback on the connected i.LINK
component.
Refer to the operating instructions supplied with the
component.
y
If multiple i.LINK components are connected to this unit, rotate
INPUT SELECTOR to select the desired i.LINK component after
step 2.
Using the Auto Play function
If your i.LINK component supports automatic playback
operations, you can use the auto play function. With auto
play, you can select from the following two playback
modes.
Auto play
When you select the i.LINK component using this unit’s
INPUT SELECTOR, playback from the selected i.LINK
component begins automatically.
Auto operation
When you start playback on the i.LINK component, this
unit automatically switches the input to select the i.LINK
component.
• To set the playback mode, use “Auto Play” in the i.LINK Select
menu (see page 99).
• Auto Play is not displayed when Input Mode is set to “Digital”
or “Analog”.
■ i.LINK indicator
Use this menu to display information about registered
i.LINK components, delete any unused registered
components, or customize the operation and playback
settings to be used when this unit is connected to an
i.LINK component.
1
Press TOP on the GUI remote control.
2
Select i.LINK Select, then press h .
3
Press k / n repeatedly to select the parameter
you want to adjust.
4
Press ENTER or h , then press k / n
repeatedly to change the setting of the item
you want to adjust.
5
Press EXIT.
Notes
I n p u t D V D
MULTI CH V–AUX DVR VCR 1 VCR 2 DTV/LD SAT CABLE DVD MD/TAPE CD–R CD TUNER PHONO
R L C
SL SR
VOLUME
LFE
i . L I N K : - - -
I n p u t D V D
MULTI CH V–AUX DVR VCR 1 VCR 2 DTV/LD SAT CABLE DVD MD/TAPE CD–R CD TUNER PHONO
R L C
SL SR
VOLUME
LFE
A u t o : - - -
or
Lights This unit plays back signals
input via i.LINK.
Flashes An i.LINK component is
connected, but this unit
plays back signals input via
sources other than i.LINK.
Goes out No i.LINK component is
connected.
Changing i.LINK Select
parameters
POWER
TOP EXIT
SYSTEM STANDBY
ENTER
1
2-4
5
00EN.00_DSPZ9_GB.book Page 98 Thursday, November 13, 2003 10:55 AM