Yamaha DSP-Z9 - Manual (Page 96)

94
ZONE 2
Using this unit’s internal amplifier
To use this unit’s internal amplifier, select ON in ZONE2 AMP.
The supplied remote control can be used to control Zone
2. You can even select the input source and control
components located in the main room directly from the
second room regardless of the listening condition in the
main room.
■ To enable Zone mode on the remote
control
This allows you to switch the remote control mode from
one room to another, and use STANDBY, SYSTEM
POWER, MUTE, and VOLUME +/– to control the
selected room.
1
Set REC OUT/ZONE 2 on the front panel to
SOURCE/REMOTE.
2
Repeat steps 1 and 2 of the procedure in
“Setting manufacturer codes” on page 81.
3
Press l / h to select “L:AMP”.
4
Press k / n to select “Zone”.
5
Press LEARN to complete the Zone setup.
The remote control is able to operate this unit from
Zone 2.
■ To control Zone 2
1
Press SOURCE SELECT k repeatedly to
display “Zone 2” in the display window.
2
Press SYSTEM POWER to turn on the power
for Zone 2.
R
+
–
PRESENCE
/ZONE 2
L
+
–
PRESENCE
/ZONE 2
Second room
This unit
Remote controlling Zone 2
PHONO DVR
REC OUT/ZONE 2
SOURCE/REMOTE
DVD DTV/LD
MD/TAPE
CD-R
CD
TUNER
VIDEO AUX
VCR 2
VCR 1
SAT
CABLE
ENTER
ENTER
LEARN
SELECT
SOURCE
00EN.00_DSPZ9_GB.book Page 94 Thursday, November 13, 2003 10:55 AM