Yamaha DSP-Z9 - Manual (Page 83)

81
English
REMOTE CONTROL FEATURES
A
D
V
ANCED
OPERA
T
ION
You can control other components by setting the
appropriate manufacturer codes. Codes can be set for each
input area.
The following table shows the input area (default
component), component category (Library) and
manufacturer code for each area.
You may not be able to operate your YAMAHA component even
if a YAMAHA manufacturer code is initially set as listed above.
In this case, try to set another YAMAHA manufacturer code(s).
1
Press an input selector button to select the
source component you want to set up.
2
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object.
“SETUP” and the selected component name appear
alternately in the display window.
Be sure to press down LEARN for at least 3 seconds,
otherwise the learning process will start.
y
Complete each of the following steps within 30 seconds.
Otherwise, the learning mode is automatically canceled. In
this case, press LEARN again.
If you want to change a library (component
category), press
l / h to set a different
component type.
Library choices: L:DVD, L:LD, L:CD, L:CDR,
L:MD, L:TAP, L:TUN, L:AMP*, L:TV, L:CAB,
L:DBS, L:SAT, L:VCR
* The amplifier Library (L:AMP) code is preset to “YPC”
to operate this unit. However, you can switch between the
following four codes if necessary.
YPC To operate this unit (without ZONE 2 features).
ZONE To operate this unit (with ZONE 2 features).
DSP To operate YAMAHA DSP amplifiers that cannot
be operated with the YPC code.
NO To operate the amplifiers of other manufacturers
using this unit’s remote control.
3
Press k / n to select the name of your
component’s manufacturer.
You will find the names of most worldwide audio-
video manufacturers in alphabetical order in the
display window.
4
Press one of the buttons shaded below to
see if you can control your component. If you
can, the manufacturer code you set is
correct.
y
• If more than one code is listed for the manufacturer of
your component, try each of them until you find the
correct one.
• If you want to continue setting up a code for another
component, press ENTER and repeat steps 1, 3 and 4.
Setting manufacturer codes
Input area Component category
(Library)
Manufacturer
code
V-AUX VCR –
TUNER TUNER YAMAHA 1
PHONO TV –
CABLE CABLE –
SAT SAT –
MD/TAPE MD YAMAHA 1
CD-R CD-R YAMAHA
CD CD YAMAHA 1
DTV/LD TV –
VCR 1 VCR –
VCR 2 VCR –
DVR DVD –
DVD DVD YAMAHA 1
Note
TUNER PHONO
CD
DVD DVR VCR 2 DTV/LD VCR 1
CD-R MD/TAPE SAT CABLE
V-AUX
LEARN
ENTER
MULTI CH IN PURE DIRECT
TOP EXIT INPUT MODE
SOUND
TITLE
MENU
CHAPTER
PAUSE STOP POWER REC
SELECT
DISPLAY
SEARCH
SOURCE
PLAY
– +
ENTER
00EN.00_DSPZ9_GB.book Page 81 Thursday, November 13, 2003 10:55 AM