Yamaha DSP-Z9 - Manual (Page 87)

85
English
REMOTE CONTROL FEATURES
A
D
V
ANCED
OPERA
T
ION
■ Macro operations
1
Set MACRO ON/OFF to ON.
2
Press a macro button.
• When you have finished using the macro feature, set MACRO
ON/OFF to OFF.
• While the remote is carrying out a macro program, it will not
accept any other button’s function until the macro operation is
complete (the TRANSMIT indicator stops flashing).
• Continue to aim the remote control at the component the macro
is operating until the macro operation is complete.
■ Programming macro operations
You can program your own macros and use the macro
feature to transmit several remote control commands in
sequence at the press of a button. Be sure to set up
manufacturer codes or perform learning operations before
programming the macro. We do not recommend
programming continuous operations such as volume
control in a macro.
• The default macro is not cleared when a new macro is
programmed for a button. The default macro can be used again
when the programmed macro is cleared.
• It is not possible to add a new signal (macro step) to the default
macro. Programming a macro changes all macro contents.
1
Press MACRO using a ballpoint pen or
similar object.
“MCR ?” appears in the display window.
y
Complete each of the following steps within 30 seconds.
Otherwise, the learning mode is automatically canceled. In
this case, press MACRO again.
2
Press the macro button you want to use to
operate the macro.
The macro button name and the selected component
name appear alternately in the display window.
• “AGAIN” appears in the display window if you press a button other
than a macro button.
• To change the selected source component, press SOURCE SELECT
k/n. Pressing the input selector buttons will program a macro step,
whereas SOURCE SELECT k/n only changes the selected
component and corresponding component control area.
3
Press the buttons for the functions you want
to include in the macro operation in
sequence.
You can set up to 10 steps (10 functions). After you
have set 10 steps, “FULL” appears and the remote
control automatically exits from the macro mode.
“NG” appears in the display window if programming was
unsuccessful. In this case, start over from step 2.
Notes
Notes
TRANSMIT RE-NAME
STANDBY TUNER
MULTI CH IN PURE DIRECT
SYSTEM
CLEAR LEARN MACRO OFF ON MACRO
PHONO
CD
DVD DVR VCR 2
TITLE
DTV/LD VCR 1
CD-R MD/TAPE SAT CABLE
POWER V-AUX
MACRO
MACRO ON/OFF
Macro buttons
MACRO
Notes
Note
TUNER PHONO
CD
DVD DVR VCR 2 DTV/LD VCR 1
CD-R MD/TAPE SAT CABLE
V-AUX
Flashes alternately
STANDBY TUNER
MULTI CH IN PURE DIRECT
TOP EXIT INPUT MODE
SOUND
SYSTEM PHONO
CD
DVD DVR VCR 2
TITLE
MENU
CHAPTER
PAUSE STOP POWER REC
SELECT
DISPLAY
SEARCH
SOURCE
PLAY
– +
ENTER
DTV/LD VCR 1
CD-R MD/TAPE SAT CABLE
POWER V-AUX
1
2
MCR 1: DVD a
MCR 2: DVD h
Indicates the
number of macro
steps entered
Flashes alternately so you can
set the next step
00EN.00_DSPZ9_GB.book Page 85 Thursday, November 13, 2003 10:55 AM