Xantrex Technology 120 VAC/60 - Manual (Page 52)

MENU SYSTEM
Page
44
 2001 Xantrex Technology, Inc.
5916 - 195th Street N. E.
Arlington, WA 98223
Telephone: 360/435-8826
Fax: 360/435-2229
www.traceengineering.com
SW Series Inverter/Charger
Part No. 2031-5
Rev. C: February 2001
SETUP MENU
The SETUP MENU provides all the controls and settings needed when installing or adjusting the system.
To access the SETUP MENU, press both the red ON/OFF MENU and green GEN MENU buttons at the
same time on the control panel of the inverter or remote control. To exit, simply go to one of the USER
MENU headings numbers 1 through 8, or press the red ON/OFF MENU or green GEN MENU button
once.
MENU HEADINGS
Inverter Setup
9
Use to program and adjust the operation of the inverter. Also allows
adjustment of how the inverter/ charger mode uses the utility grid.
Battery Charging
10
Use to adjust the operation of the battery charger.
AC Inputs
11
Use to adjust the operating characteristics of the utility grid (AC1) and the
generator (AC2) inputs.
Gen Auto Start
setup
12
Use to setup the when the automatic generator control system and the
maximum run time allowed
Gen starting
details
13
Use to adjust the starting sequence of the automatic generator control
system.
Auxiliary Relays
R9 R10 R11
14
Use to adjust the operation of the auxiliary signal relays for controlling
external power sources or system loads.
Bulk Charge
Trigger Timer
15
Use to set a time when the battery will be given a bulk charge cycle from the
utility grid (AC1) input. Usually only used when SLT mode is enabled.
Low Battery
Transfer (LBX)
16
Use to set up the transfer voltage setting for the LBX mode.
Battery Selling
17
Use to control the SELL mode when it is used to discharge a battery into the
utility grid. Also allows setting of the maximum sell amps.
Grid Usage Timer
18
Use to control when the inverter/charger mode uses the utility grid for the
FLT and SELL modes.
Information File
battery
19
Provides information about the operation of some settings and meters.
End Setup Menu
20
Used to display that you have reached the end of the SETUP MENU.