Zebra Technologies PrintServer User Manual
Page 32
Installation
External PSII
PrintServer II User and Reference Guide
21
This illustration calls out the location of the parallel port and provides a blown up
illustration of the parallel port:
3. Secure the wire locks.
4. On the back of the
PSII
, insert a live 10BASE-T cable into the Ethernet connector.
5. Power on the printer.
An red status indicator blinks during the POST (Power On Self Test) and changes
to green when stabilized.
6. Press the test button located on the side of the
PSII
. This prints out a configuration
label of
PSII:
Note • To determine the minimum label width needed to print a
PSII
configuration
label, refer the following list of printhead resolutions:
• 600 dpi (1.25 inch)
• 300 dpi (2.50 inch)
• 200 dpi (3.69 inch)
• 150 dpi (5.0 inch)