Zebra Technologies PrintServer - Manual (Page 36)

Installation
Internal PSII
PrintServer II User and Reference Guide 25
.
4. Through the mounting slot, insert the ribbon cable and PSII .
5. Fold the cable and the ferrite bead back over the mounting bracket, and connect the
ribbon cable connector into the keyed Interface Data Cable Connector (J4) on the
main logic board.
Confirm that the connector is properly seated and that pin 1 of the Interface Data
Cable Connector is connected to pin 1of J4.
6. Secure the PSII interface board in place with the cover plate screws that you
removed early in this step sequence.
7. Confirm that all small cable connectors are tight.
8. Reinstall the PAX-Series PCB access panel or the left side-panel of the XiII and
XiIII-Series printers that you removed earlier in this step sequence.
9. This kit includes a label printed with the Ethernet MAC hardware address for the
PSII . Remove the backing from the label and affix it to the back of the printer.
10. Reconnect the AC power cord and turn the printer power on.
Note • The parallel port on the back of the printer is not operational when the
internal
PSII is installed. The hardware of the PSII mounting bracket covers the
parallel port.