Yeoman EXE MIDI PR1145 - Manual (Page 15)

15
IGNITION
FUNCTIONAL
CHEC
k
1
PILOT
WILL
NOT
LIGHT
Ensure
there
is
no
debris
around
the
pilot
assembly,
(e.g.
soot,
etc.)
which
could
short
the
spark,
clean
the
area.
Operate
the
valve.
Is
there
a
spark?
Consult
Section
2
and
retry.
Check
alignment
of
pilot
burner
head,
change
the
ignition
lead,
see
Diagram
1
on
page
14.
Check
isolation
tap
and
gas
meter,
retry.
Correct
and
retry.
Purge
the
gas
pipes
and
retry.
SEE
'NO
SPAR
k'
CHART
SYSTEM
O
k
There
is
a
blockage
in
the
system,
check
the
inlet
test
point,
the
mag
seating,
valve
and
pilot
filter. Is
the
gas
turned
on
to
the
appliance?
Is
the
gas
pressure
correct?
Has
the
system
got
any
air
in
it?
Does
the
pilot
light?
Is
the
control
being
operated
correctly?
Will
the
pilot
light
with
a
match?
No
Yes
No Yes No Yes Yes No
No
Yes
No
No
Yes
Yes
SERVICING INSTRUCTIONS
SERVICING REQUIREMENTS/ FAULT FINDING CHARTS
1. SERVICING REQUIREMENTS
IMPORTANT – The glass panel on this appliance should
be checked for any signs of damage on the front face of
the glass panel (scratches, scores, cracks or other surface
defects). If damage is observed, the glass panel must be
replaced and the appliance must not be used until a
replacement is installed. Under no circumstances should
the appliance be used if any damage is observed. Please
isolate the appliance until a replacement glass panel has
been obtained and installed. Replacement glass panels
can be purchased from Gazco via the retailer from which
the appliance was purchased or any other Gazco
distributor.
This appliance must be serviced at least once a year by a
competent person. All tests must be serviced by best
practice as described by the current Gas Safe
recommendations.
1.1 Before any test are undertaken on the appliance, conduct a
gas soundness test for the property to ensure that there are
no gas leaks prior to starting work.
1.2 Before any tests are undertaken on the appliance it is also
recommended to fully check the operation of the appliance.
1.3 Special checks:
—
Clean any lint or fluff from the pilot - pay particular
attention to the aeration hole in the side of the pilot.
—
Clean away any fluff or lint from under the burner.
—
Check that the spark gap on the pilot is correct.
1.4 Correct any faults found during the initial tests and then
re-commission the appliance conducting the usual safety
checks.
1.5 Advise the customer of any remedial action taken.
AR0097
3.5mm
15mm