Removing and replacing cameo 2 battery packs, Removing and replacing cameo 2, Battery packs ...............................o-11 – Zebra Technologies Mobile Printer User Manual
Page 11: Battery packs
O-11
Cameo 2/3 Series User Guide
Removing and Replacing Cameo 2
Series Battery Packs
Removing and Replacing Cameo 2
Battery Packs
To remove the battery pack from the Cameo 2:
1. Push the battery release button on the bottom of the
printer towards the media compartment.
2. Rotate the belt clip as shown while,
3. Allowing the battery pack to slide out.
Battery Packs are replaced by the following procedure:
1. Rotate the Belt Clip to clear the battery
2. Align the battery pack to the bottom of the printer. The
side of the battery with the contacts will face into the well
for the battery.
3. Slide the pack completely into the printer until it locks in
place. The battery will engage with a distinct “click”.
4. Rotate the Belt Clip back into position.
Belt Clip
Push Release Latch to
remove battery pack.
Battery Pack
Charger Jack