Zebra value radio, 802.11b for cameo 3 – Zebra Technologies Mobile Printer User Manual
Page 25
O-25
Cameo 2/3 Series User Guide
0336
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.
Zebra Value Radio, 802.11b for Cameo 3
The following section only applies when the Zebra Value Radio, 802.11b (with FCC ID: I28MD-ZLAN11B)
is installed in a Cameo 3 printer. The FCC ID number is on the serial number label on the back of the printer
and can be read with the module installed. Note that only one of the radio options can be installed in the
printer at one time and the antenna used for these transmitters must not be co-located or must not operate
in conjunction with any other antenna.
Caution • The radiated output power of this internal 802.11b radio is far
below the FCC radio frequency exposure limits. Nevertheless, this radio
must be used in such a manner that the antenna is 2.5 cm. or further
from the human body. The radio and antenna are mounted internally
in this printer such that when the printer is worn with the back of the
printer against the body and the front of the printer (where paper exits)
away from the body, then the 2.5 cm distance between the antenna and
the users body will be met. Do not use the printer in an unauthorized
manner.
European Regulatory Information for this Radio
AT
BE
CY
CZ
DK
EE
FI
FR
DE
GR
HU
IE
IT
LV
LT
LU
MT
NL
PL
PT
SK
SI
ES
SE
GB
Note: -Member states in the EU with restrictive use for this device are
crossed out!
This device is also authorized for use in all EFTA member states (
CH, IS, LI, NO)
continued