Zebra Technologies Mobile Printer - Manual (Page 12)

O-12
Cameo 2/3 Series User Guide
Removing and Replacing Cameo 3 Battery Packs
To remove the battery pack from the Cameo 3:
Slide the Battery Latch button in the direction shown in the
top illustration below, and slide the battery out.
To replace the battery, insert the end with the contacts into
the battery well and slide the battery into the printer until in
clicks into place. Always dispose of battery packs properly.
Refer to Appendix D for more information on battery pack dis-
posal.
Removing and Replacing Cameo 3 Battery Packs
Low Battery Shutdown
As the battery charge level in becomes depleted the Power
LED will flash. At this time the printer should be shut off and
the battery pack recharged or replaced. Cameos will automat-
ically shut off if the batteries become severely discharged.
Safety Warnings
Caution • Battery terminals are recessed to prevent short circuiting of
the battery. Allowing these terminals to contact conductive material
will create a short circuit which could cause burns, other injuries or
start a fire.
Battery Pack
Battery Latch
Button