Zebra Technologies Mobile Printer - Manual (Page 24)

O-24
Cameo 2/3 Series User Guide
Radio Regulatory Information
Bluetooth Radio for Cameo 2 and Cameo 3
The following section only applies when the Bluetooth ZBR3 Module is installed in the Cameo 2 or Cameo
3 printers. Cameo 2 printers with the Bluetooth radio have an FCC ID: I28MD-BTC2TY2. Cameo 3 printers
with the Bluetooth Radio could have an FCC ID: I28MD-BTC2TY5 or I28MD-BTC2TY2. Note that only one of
the radio options can be installed in the printer at one time.
“Bluetooth” is a worldwide standard for the exchange of
data between two devices via radio frequencies. Bluetooth
radios are relatively low powered to help prevent interfer-
ence with other devices running at similar radio frequencies.
This limits the range of a Bluetooth device to about 10 meters
(about 32 feet).
Both the printer and the device it communicates with must
follow the Bluetooth standard.
Caution • Exposure to Radio Frequency Radiation. The radiated output
power of this internal Bluetooth radio is far below the FCC radio
frequency exposure limits. Nevertheless, this Bluetooth radio must
be used in such a manner that the antenna is 2.5 cm or further from
the human body. The radio and antenna are mounted internally in this
printer such that when the printer is worn with the back of the printer
against the body and the front of the printer (where paper exits) away
from the body, then the 2.5 cm distance between the antenna and
the users body will be met. Do not use the printer in an unauthorized
manner. The internal Bluetooth radio operates within guidelines found
in radio frequency safety standards and recommendations. The level of
energy emitted is far less than the electromagnetic energy emitted by
other wireless devices such as mobile phones.
European Regulatory Information for the ZBR3 Bluetooth Radio
This device is intended for use in all EU and EFTA member states.
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive
1999/5/EC. The following test methods have been applied in order to prove
presumption of compliance with the R&TTE Directive 1999/5/EC:
• EN 60950: 2000
Safety of Information Technology Equipment
• EN 300 328-2 V1.4.1 (2003-04)
Technical requirements for spread-spectrum radio equipment
• EN 301 489-1/-17 V1.4.1/1.2.1 (2002-08)
EMC requirements for spread-spectrum radio equipment.
This device is a 2.4 GHz wireless LAN transceiver, intended for indoor home and
office use in all EU and EFTA member states.
0336
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU
and EFTA member states.