Zebra Technologies Mobile Printer - Manual (Page 9)

O-9
Cameo 2/3 Series User Guide
Controls
Keypad Functions
Power Light (grn) Status Light (yellow)
Off On Blink Off On Blink
Cameo 2/3
(cable)
Power Off Power On
Low Battery
Warning
Normal
Latch open
or out of
media
MCR ready
for card
swipe
Cameo 2/3
(Ir or BT)
Power Off Power On
Low battery
Warning
Normal
Latch open
or out of
media
MCR ready
for card
swipe
Random
blinking
indicates
data
transmission
Cameo 3
(WLAN)
Power Off
Power On
Low Battery
Warning
and/or
Radio not
connected to
WLAN
Normal
Latch open
or out of
media
MCR ready
for card
swipe
Radio
connected to
WLAN*
* Connection to a WLAN does not guarantee that communications are enabled. Passwords and/or other
network settings must also be correct.
Self Test
Cameos can perform a self test which verifies proper op-
eration of the printhead and then prints a report on software
loaded in the printer. Refer to the Troubleshooting section for
complete details on performing and interpreting the self-test.
On Switch:
Momentary action turns
on unit
IR Window:
Units with IR option only: Must be
aligned with corresponding window on
host for IR communications to occur.
Feed Switch:
Advances media when
held down.
Status Light:
Refer to table below for Status Light
indications
Power Light:
Refer to table below
for Power Light
indications