Yamaha R-V1103 - Manual (Page 24)

22
4. CENTER SPEAKER
Choices: NRML/WIDE/PHNTM
Preset position: NRML
NRML (Normal):
Select this position when you use a center speaker
that is smaller than the main speakers. In this
position, low bass signals (below 90 Hz) at the center
channel are output from the main speakers (or the
SUBWOOFER OUTPUT terminal if the SMALL
position is selected on “6. MAIN SPEAKER” and the
SWFR position is selected on “7. LFE/BASS OUT”).
WIDE: Select this position when your center speaker is
approximately the same size as the main speakers.
PHNTM (Phantom):
Select this position when you do not have a center
speaker. The center channel sound will be output
from the left and right main speakers.
5. REAR SPEAKER
Choices: SMALL/LARGE
Preset position: SMALL
SMALL: Select this position if your rear speakers do not have
a high ability for bass reproduction.
In this position, low bass signals (below 90 Hz) at the
rear channels are output from the SUBWOOFER
OUTPUT terminal (or the main speakers if the MAIN
position is selected on “7. LFE/BASS OUT”).
LARGE: Select this position if your rear speakers have a high
ability for bass reproduction, or a subwoofer is
connected to the rear speaker in parallel.
In this position, full range signals are output from the
rear speakers.
6. MAIN SPEAKER
Choices: SMALL/LARGE
Preset position: LARGE
SMALL: Select this position if your main speakers do not have
a high ability for bass reproduction. However, if your
system does not include a subwoofer, do not select
this position.
In this position, low bass signals (below 90 Hz) at the
main channels are output from the SUBWOOFER
OUTPUT terminal (if the SWFR or BOTH position is
selected on “7. LFE/BASS OUT”).
LARGE: Select this position if your main speakers have a high
ability for bass reproduction.
In this position, full range signals present at the main
channels are output from the main speakers.
7. LFE/BASS OUT
Choices: MAIN/SWFR/BOTH
Preset position: SWFR
MAIN: Select this position if your system does not include a
subwoofer.
In this position, full range signals present at the main
channels, signals from the LFE channel and other
low bass signals that are selected on “4. CENTER
SPEAKER” to “6. MAIN SPEAKER” to be distributed
from other channels are output from the main
speakers.
SWFR/BOTH:
Select either the SWFR or BOTH position if your
system includes a subwoofer.
In either position, signals at LFE channel and other
low bass signals that are selected on “4. CENTER
SPEAKER” to “6. MAIN SPEAKER” to be distributed
from other channels are output from the
SUBWOOFER OUTPUT terminal.
When the LARGE position is selected on “6. MAIN
SPEAKER”, in the SWFR position, no signal is
distributed from the main channels to the
SUBWOOFER OUTPUT terminal, however in the
BOTH position, low bass signals from the main
channels are output to both of the main speakers and
the SUBWOOFER OUTPUT terminal.
SELECTING THE OUTPUT MODES SUITABLE FOR YOUR SPEAKER
SYSTEM
This unit provides you the following four functions to determine the method of distributing output signals to speakers suitable for
your audio system. When speaker connections are all completed, select a proper position on each function to make the best use of
your speaker system.
4. CENTER SPEAKER (CNTR)
5. REAR SPEAKER (REAR)
6. MAIN SPEAKER (MAIN)
7. LFE/BASS OUT (BASS)
ADJUSTMENTS BEFORE USING THIS UNIT
DESCRIPTION OF EACH FUNCTION