Yamaha R-V1103 - Manual (Page 40)

38
ADJUSTING DELAY TIME AND EACH SPEAKER OUTPUT LEVEL
In using the digital sound field processor including the Dolby Pro
Logic Decoder or the Dolby Digital (AC-3) Decoder, you can
adjust delay time between the main sound and effect sound, and
each speaker output level as you prefer. Note: These adjustments can be made only when the effect
sound is on. If none of the indicators
, and
are not illuminated on the display panel, press
the EFFECT switch on the front panel or the EFFECT ON/OFF
key on the remote control transmitter so that at least one of
those indicators lights up on the display panel.
PRO LOGIC
DIGITAL DSP
If you will use the remote control transmitter, set the
TIME/LEVEL·SET MENU switch to the TIME/LEVEL
position on the remote control transmitter.
Note: Be sure to use the remote control transmitter with the
lid open.
1
Press once or more until the name of item on which you
will make an adjustment appears on the display panel.
Whenever pressed, the selection changes as the above chart
shows.
* Pressing the key on the remote control transmitter
changes the selection in the reverse order.
* Depending on a mode of this unit, you cannot select all
items.
2
Adjust the level on the selected item.
3
Repeat step 1 and 2 to make adjustments on other items.
Front panel
or
Remote control
DELAY/CENTER
/REAR/SWFR
SET
MENU
D E L A Y
C E N T E R
R S U R .
L S U R .
S W F R
(Delay time)
(Center speaker output level)
(Right rear speaker output level)
(Left rear speaker output level)
(Subwoofer output level)
or
Front panel Remote control
DELAY/CENTER
/REAR/SWFR
SET
MENU
Method of adjustment
TIME/LEVEL
SET MENU