Zoom PS-02 - Manual (Page 21)

Operation
Guide
21
• For information on available rhythm patterns, see the "Rhythm Pattern
List" on page 83.
• During programming, you can use the [ ] and [
■] key to play and stop
the pattern.
• When pattern change information is entered in a measure, that pattern will
be repeated until the measure where the next pattern change information
is input.
• The EFFECT PATCH [
▲]/[▼] keys can also be used to change the pattern.
3.
Use the cursor [ ]/[ ] keys to move to the number of the
measure where the pattern should change next ("4" in this
example).
For measures where no pattern change information is input, the
display shows "PTN<--" as in the illustration below.
4.
Use slider 3 to enter the pattern change information for
measure 4 ("FILL08 / ROCK / F8-1-1" in this example.
When entering a pattern change information where only the variation is
different from the immediately preceding pattern, you can omit the style and
section input.
5.
In the same way, enter pattern change information for
measures 5, 8, and 9.
◆
Editing/deleting pattern change information
• To edit entered pattern change information, use the pattern input
display and go to the measure number whose contents you want to
change. Then use sliders 1 - 3 to specify the desired new pattern.
• To delete entered pattern change information, use the pattern input
display and go to the measure number whose contents you want to
delete. Then set slider 1 to the full down position.
• The indication "------" is temporarily shown on the display and then
changes to "PTN<--". The selected pattern change information has
now been erased.
PATTERN CHORD RECORD MIXDOWN