Zoom PS-02 - Manual (Page 78)

78
Troubleshooting
T
roubleshooting
Problem Remedy
Are manganese batteries being used? Alkaline
batteries are recommended. Batteries are used up
quickly
The contact strip of the SmartMedia may be
dirty. Clean it by lightly wiping it with a soft
cloth.
"CRDERR" (Card Error) is
displayed
Card may not be fully inserted. Remove card
and insert again.
"NOCARD" is displayed
when SmartMedia card is
inserted
Newly bought SmartMedia card without system
data was inserted. Format card and place system
data on it (
➝ page 73).
Wrong menu is selected. Change menu and then
operate slider.
Rhythm and audio track
sound is not heard, also
when turning slider up
Remaining capacity of SmartMedia is
insufficient. Erase unneeded audio data
(
➝ page 54, 59, 60).
"FULL" is displayed
MICPRE effect is being used.
Sound from [INPUT] jack
(guitar etc.) is extremely
distorted
If amp modeling effect type is selected in
DRIVE module, CAB module cannot be used. CAB (Cabinet Simulator)
module cannot be used
"AUX" not selected as recording source
(
➝ page 53).
Cannot record signal
from [AUX] jack
PAN setting was not carried out for bounced
tracks (
➝ page 55).
Bouncing to stereo was
carried out, but sound
stage is narrow
If MICPRE is not selected for DRIVE module,
built-in microphone cannot be used. Built-in microphone
cannot be used
MIXEFX effect is being used.
Input level slider is turned down. Turn up slider
1 at Song menu.
Signal from [INPUT] jack
is not heard