Zoom ST-224 - Manual (Page 12)

12
Quick
Guide
OUTPUT
R DATA CARD MIDI IN DC IN POWER L/MONO P
EFFECT
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW-PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5 3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
COPY DELETE
EXIT
AUTO SYNC
PLAYLIST
TAP BPM
SONG
PLAY/STOP REC
MEASURE
BPM/VALUE
BA
LOAD SAV
Use the [EFFECT SELECT]
switch and [EFFECT BANK] key
to select the desired effect type.
Turn the [EFFECT SELECT] switch so that it
points to the name of the desired effect.
When LED A is lit, non-underlined effects
can be selected. When LED B is lit,
underlined effects can be selected ( ➔ p.46 ).
While holding down the
[EFFECT PAD ENABLE] key,
press the pad to which you
want to assign effect.
The LED of the selected pad lights up. It
is also possible to select several pads.
[Preparations ]
•Connect the ST-224 to the playback equipment ( p. 8 ).
•Turn power on in the order ST-224 playback equipment.
OUTPUT L/MONO PHONES
OUTPUT R Playback equipment.
Headphones
ZOOM CORPORATION
MADE IN JAPAN
MODEL
L/ MONO PHONES R DATA CARD MIDI IN DC9V
300mA
POWER
OUTPUT
L/ MONO LINE/MIC R
INPUT
The ST-224 incorporates built-in effects with 22 effect types. Among these, you can select any desired effect
and assign it to a pad.
Quick Guide (3) Assign an Effect to a Pad