Using the internal effects, Applying an effect to a specific pad, Step – Zoom ST-224 User Manual
Page 42: Step applying an effect to a specific pad
The ST-224 has 22 types of built-in effects. You can select any effect and apply it to the sound of any pad. The
[EDIT 1] wheel and [EDIT 2] knob on the unit can be used to adjust effect parameters in real time. It is also
possible to synchronize a specific effect parameter with a certain BPM value.
Using the Internal Effects
42
Using
the
Internal
Effects
Rotate the [EFFECT SELECT] switch so that it points to the desired
effect type. Use the [EFFECT BANK] key to switch between bank A
(effect types without underline) and bank B (effect types with
underline).
The LEDs of the selected pads light up, and the sound from these
pads will be processed by the effects section.
By pressing the [SOURCE] pad, the input source that is controlled
by the [SOURCE] pad (
➔
) can also be routed to the effects
section (excluding certain effect types).
The TIME STRETCH/SCRATCH effect can be applied only to
sampled sound.
While the [EFFECT ON/OFF] key is held down, the [EFFECT ON/OFF]
LED is lit and the effect is on.
HINT
HINT
NOTE
This section explains how to select an effect type, apply an effect to a pad, and how to adjust effect
parameters.
BANK
3
BANK
2
BANK
SONG
PAD
1
FUNCTION
PAD ASSIGN CAPACITY
ERASE OPTIMIZE
PLAY/STOP
RECORD
RE-SAMPLE
GRADE
MONO
STEREO
SAMPLING
EFFECT
EDIT 2
VOLUME/BASS
EXCITER
TREMOLO
AUTO PAN
LO-FI EFFECT
EXTREME EQ
COMPRESSOR
RESONANCE
HIGH-PASS
LOW-PASS
DISTORTION
RING MODULATOR
PITCH SHIFTER
DIMENSION
CHORUS
PHASER
FLANGER
STEP CRY
DELAY
REVERB
TIME STRETCH
SCRATCH
EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
EDIT 1
LOOP/MARK
4
SHIFT
OFFSET
6
SWING
PANNING
8
MIDI
TRIGGER/GA
TE
2
QUANTIZE
TUNING
SOURCE
SOURCE MIX
5
PRE COUNT
END POINT
3
TIME SIG
START POINT
1
BAR LENGTH
LEVEL
7
CLICK VOLUME
REVERSE
COPY
DELETE
BACKUP
EXIT
SPECIAL
LOAD
SAVE
INTERNAL/DATA CARD
+
–
AUTO SYNC
PLAYLIST
TAP
BPM
SONG
PLAY/STOP
REC
BPM/VALUE
MEASURE
SAMPLE/SONG
BEAT
+
EFFECT
A
B
[EFFECT SELECT]
switch
PAD ENABLE
BANK
1
+
BANK 1– 3 keys
Pad
Use the [EFFECT SELECT] switch and [EFFECT BANK] key to select the effect type.
1
STEP
Hold down the [EFFECT PAD ENABLE] key and use the [BANK 1] - [BANK 3] keys and the
pads 1 - 8 to select the pad to which to apply the effect. (Multiple pads can be selected.)
2
STEP
While holding down the [EFFECT ON/OFF] key, hit the pad you selected in step 2.
3
STEP
Applying an Effect to a Specific Pad
ON/OFF